I had this working for a while with my Netgear and AirportExpress, but then i just switched to the airportexpress in a more central location. However, if one router uses multicasting, then all routers on your network must use multicasting. Note: Multicasting can reduce the load on non-router machines because they do not listen to the RIP multicast address and will not receive the RIP packets. Both RIP-2B and RIP-2M send the routing data in RIP-2 format. RIP-1 is probably adequate for most networks, unless you have an unusual network setup. (It recognizes both formats when receiving.) By default, this is set for RIP-1. * RIP Version: This controls the format and the broadcasting method of the RIP packets that the gateway sends. O When set to None, it will not send any RIP packets and will ignore any RIP packets received. O When set to Both or In Only, it will incorporate the RIP information that it receives. O When set to Both or Out Only, the gateway will broadcast its routing table periodically. The RIP Direction selection controls how the router sends and receives RIP packets. * RIP Direction: RIP (Routing Information Protocol, RFC1058 and RFC1389) allows a router to exchange routing information with other routers. Some stuff from my netgears LAN IP Setup page: Umm its a bit complex but if your routers have support you can enable RIP Direction after making one router join the others network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |